玻璃 钢化玻璃 金属制品(铜 铁 铝 锌 氧化铝 不锈钢等) 较终产品举例:电器铭牌 灯具表面 日用玻璃制品等。 产品特征 1、低气味,**高光泽,高硬度(达到3H). 2、高附着力,可通过百格,耐胶粘及指刮测试。 3、耐化学性:各种酒精、783和天那水的反复擦拭。 4、耐水性:可通过水煮1个小时测试。 5、双组份:添加GF-G223固化剂为5-8%. 6、环保性:符合欧洲ROHS标准。 网版及用量 1、网目:150-420网目。 2、用量:每公斤用350目网版约可印刷40平米。 干燥 1、自干:约15-30分钟可表干,实干48小时。(在300目网版印刷) 2、烘烤:经过5-10分钟烘烤(100-160度)后,可快速固化。 稀释和洗网 使用前先加:10-30%溶剂稀释油墨后印刷,连续或间断印刷后应用洗网水环B清洗。 可使用溶剂:4001低气味慢开油水、环保(783慢干水、718中干水、719快干水) 注意:使用本产品批量印刷前,必须对油墨进行试验,印品放置24-96小时后测试油墨是否符合印品要求,如果印品需要多层印刷,应使用所需基材进行多层印刷后测试油墨,认可后方可投入生产。Glass tempered glass metal products (copper, iron, aluminum, zinc, aluminum, stainless steel, etc.) The final product example: Electrical nameplate lamp surface glass products etc.. Product features 1, low odor, high gloss, high hardness (3H). 2, high adhesion, can be through one hundred, resistance to adhesive and scratch test. 3, chemical resistance: a variety of alcohol, 783 and the day that the water repeatedly wipe. 4, water resistance: can be boiled 1 hours of testing. 5, two components: the addition of GF-G223 curing agent for 5-8%. 6, environmental protection: in line with the European ROHS standards. Screen and dosage 1 mesh, 150-420 mesh. 2, dosage: every kilograms of 350 mesh screen printing about 40 square meters. dry 1, since the dry: about 15-30 minutes to dry, hard work 48 hours. (printed on 300 mesh screen) 2, baking: after 5-10 minutes of baking (100-160 degrees), can be quickly cured. Dilution and washing Prior to use: 10-30% solvent dilution ink after printing, continuous or intermittent printing after the application of washing network water ring B cleaning. Use solvent: 4001 low odor slow open water, environmental protection (783 and 718 in dry water, retarder, 719 drying water) Note: use this product batch before printing, it is necessary to test the ink, the printing place 24-96 hours after ink testing is in accordance with the printing requirements, if the printing needs of multilayer printing, should use the required substrate multilayer printed ink testing and approval can be put into production.